Shapeoko 3 - Assembly Instructions (preliminary)

[woodinturn]

I understand that there has been some chatter about post processor for V Carve software. where do I need to go to find the posts concerning the P/P. If I'm wrong does anyone have any thoughts on P/P for V Carve

[WillAdams]

Everything should be linked on the wiki: http://www.shapeoko.com/wiki/index.php/ ... e#2.5D_CAM

[adamd]

Just to let everyone know what I found out, here's the following reply from Edward:

"We *should* have the new manual done by the end of the week. I saw a build late last week and it's looking great.

Feel free to send me an email on Friday requesting a ink. If it's done, I'll send it right over."

Good news for those of us putting one together soon! (and thanks to those who have put info in the wiki as well)
Adam

[CastIrony]

Did anything happen this week?

[adamd]

Edward sent me another note on Thursday saying he planned to have it out on Friday. I'm sure it's imminent at this point.

Adam

[sjj47]

I just received my shipment . Anything further on the new instructions?

[woodinturn]

Congrats on your new purchase, just be sure you read the instructions at lest four times before even taken it out of the box!!! Have fun! This is from one who knows.

[RoguePirin]

I just received my shipment . Anything further on the new instructions?

Me too! Anxiously awaiting the updating Assembly Instructions.

[BennettBenson]

Any update on the new Assembly instructions?

[edwardrford]

Hi All,

Here's a link to the *almost* completed assembly guide: http://bit.ly/1VMlUTr

-Edward