Page 1 of 5

Official SO3 Hello World

Posted: Thu Jun 18, 2015 5:17 am
by WillAdams
This is on the Carbide3D knowledge base site:

http://docs.carbide3d.com/article/37-sh ... ello-world

Looking forward to seeing them posted here and to the wiki.

Re: Official SO3 Hello World

Posted: Thu Jun 18, 2015 6:55 am
by Brian Stone
Minor spelling error...
6.) Job pen down until it's *almost* touching the paper.

Re: Official SO3 Hello World

Posted: Thu Jun 18, 2015 12:41 pm
by Hans
Racing league, racing league, racing league!

I like the variety of different text sizes, that should make it easier to see any problems. Order of operations is probably efficient, but I'd prefer it didn't do SHAPEOKO in parts as if the machine was easily distracted.

Re: Official SO3 Hello World

Posted: Thu Jun 18, 2015 2:15 pm
by twforeman
Excellent. I'll have to see how fast I can run this. :)

Re: Official SO3 Hello World

Posted: Fri Jun 19, 2015 12:40 am
by Defy
Just makes me want a carbide 3d sticker for my shapeoko...

Re: Official SO3 Hello World

Posted: Fri Jun 19, 2015 2:18 am
by edwardrford
Defy wrote:Just makes me want a carbide 3d sticker for my shapeoko...
Me too!

We had a stack of those badges that we use for all of our Nomad machines. Ends up, they look great on the S3 spindle mount too!

We've ordered a bunch more, once they're delivered, we'll make them available.

-Edward

Re: Official SO3 Hello World

Posted: Fri Jun 19, 2015 2:35 am
by twforeman
Well that was fun. I cranked up the settings on my machine and ran this Hello World at 35,000 mm/min. I set the acceleration rate to 500 also. The machine did it but it wasn't super happy about it. :)

I shot some video, but it's out of focus, so I'll have to do it again.

Re: Official SO3 Hello World

Posted: Fri Jun 19, 2015 3:21 am
by woodworkerbob
WillAdams wrote:This is on the Carbide3D knowledge base site:

http://docs.carbide3d.com/article/37-sh ... ello-world

Looking forward to seeing them posted here and to the wiki.
For those of us Luddites that run jobs in inches, DON'T RUN THIS GCODE after any of those jobs. I think without the G21 command the controller stays in "inches" mode. Maybe a smarter person knows that the controller reverts to millimeters, but I haven't tested this.


Bob

Re: Official SO3 Hello World

Posted: Fri Jun 19, 2015 5:58 am
by CastIrony
twforeman wrote:Well that was fun. I cranked up the settings on my machine and ran this Hello World at 35,000 mm/min. I set the acceleration rate to 500 also. The machine did it but it wasn't super happy about it. :)

I shot some video, but it's out of focus, so I'll have to do it again.
Yeah, but where will you get more paper? :lol:

Re: Official SO3 Hello World

Posted: Mon Jun 29, 2015 10:31 am
by Jem-tech
Just got my new board in and did a few hello worlds. :D