Page 2 of 2

Re: shapeoko 3 z axis

Posted: Wed Aug 26, 2015 12:32 am
by cvoinescu
CastIrony wrote:Why the heck would Easel do that? Even if it's assuming you have a SO2 or X-Carve, you still might want to tweak that value and not have it be randomly overwritten by your CAM app.
Heck if I know. I'm basing this on several reports of Easel having done this. I don't use Easel.

Re: shapeoko 3 z axis

Posted: Thu Aug 27, 2015 11:27 pm
by jgarza
$0=10 (step pulse, usec)
$1=255 (step idle delay, msec)
$2=0 (step port invert mask:00000000)
$3=6 (dir port invert mask:00000110)
$4=0 (step enable invert, bool)
$5=0 (limit pins invert, bool)
$6=0 (probe pin invert, bool)
$10=255 (status report mask:11111111)
$11=0.020 (junction deviation, mm)
$12=0.010 (arc tolerance, mm)
$13=0 (report inches, bool)
$14=1 (auto start, bool)
$20=0 (soft limits, bool)
$21=0 (hard limits, bool)
$22=0 (homing cycle, bool)
$23=0 (homing dir invert mask:00000000)
$24=100.000 (homing feed, mm/min)
$25=1000.000 (homing seek, mm/min)
$26=25 (homing debounce, msec)
$27=5.000 (homing pull-off, mm)
$100=20.000 (x, step/mm)
$101=20.000 (y, step/mm)
$102=320.000 (z, step/mm)
$110=5000.000 (x max rate, mm/min)
$111=5000.000 (y max rate, mm/min)
$112=5000.000 (z max rate, mm/min)
$120=400.000 (x accel, mm/sec^2)
$121=400.000 (y accel, mm/sec^2)
$122=400.000 (z accel, mm/sec^2)
$130=290.000 (x max travel, mm)
$131=290.000 (y max travel, mm)
$132=80.000 (z max travel, mm)

THESE ARE MY SETTING AS OF TODAY.

Re: shapeoko 3 z axis

Posted: Fri Aug 28, 2015 12:13 am
by WillAdams
Please see: http://docs.carbide3d.com/article/38-sh ... l-settings
$102=20 (z, step/mm)
not 320.

Re: shapeoko 3 z axis

Posted: Sat Aug 29, 2015 9:14 pm
by jgarza
your right I copied and paste and hit send and it changed it, working great.