What Part/Pins for Soldering onto the Unpopulated Holes?

Assembly questions and answers for the Shapeoko 3 CNC Mill
Post Reply
mankyd
Posts: 36
Joined: Tue Jan 13, 2015 2:38 am

What Part/Pins for Soldering onto the Unpopulated Holes?

Post by mankyd » Sat Dec 19, 2015 2:02 am

The carbide motion board has 6 holes on the right side of the board that are shipped without headers soldered in: https://s3.amazonaws.com/helpscout.net/ ... iagram.pdf

Does anyone know a specific part number for pins that can be soldered into them? the .1" pitch pins I have are slightly too small. I am thinking is 3mm pitch. I suck at searching part catalogs and have come up empty handed so far.
Shapeoko 3 #147
Headless Controll via Raspberry Pi
SuperPID2
Touch Plate
Hall Effect Limit Switches in the Works

http://ohthehugemanatee.net/

RoguePirin
Posts: 216
Joined: Wed Sep 02, 2015 3:22 pm
Location: Illinois, USA

Re: What Part/Pins for Soldering onto the Unpopulated Holes?

Post by RoguePirin » Sat Dec 19, 2015 2:21 am

I don't have an exact part number, but I did hear from support as to the type of header to use.
Shapeoko 3 #677, Nyloc nuts, ¾" HDPE base with t-nuts, Dewalt 611 w/Super PIDv2

Post Reply