new x-axis and z-axis plates -- updated instructions?

Assembly questions and answers for the Shapeoko 3 CNC Mill
kevinchartier
Posts: 6
Joined: Fri Jun 03, 2016 12:15 pm

Re: new x-axis and z-axis plates -- updated instructions?

Post by kevinchartier » Sat Jun 04, 2016 6:52 pm

Response from Edward:
The correct screw is a socket head m4x25mm.

Do not overtighten then belt! You will bend the shaft on the stepper motor.
I was just being overly cautious with the m4 screw I had. After I got this response, I tried it again, and it went in just fine. :)

Post Reply