Need new limit switch- Z axis lets go and destroyed it. Part

almus · Post by **almus** » Mon Sep 12, 2016 8:08 pm

I noted that other(s) have had the issue of the z axis slipping back under the tension of the springs. In my case,
the Z axis slammed back so hard to "0" that it destroyed the limit switch. Machine is shapeoko 3 only about ~1 month old

Where does one find spare replacement parts? Is there a digikey part number for the swithch?
I can just resolder if I can find the right one that fits the hole pattern etc.

Help!

Thanks

Post by **WillAdams** » Mon Sep 12, 2016 8:17 pm

per yfiYacine Filali http://community.carbide3d.com/t/so3-ex ... rts/1882/3

Omron D2QW-C003H

http://www.digikey.com/product-detail/e ... ND/2698560

RoguePirin · Post by **RoguePirin** » Tue Sep 13, 2016 1:37 pm

Yes, the one Will referenced is the correct part number.

Note that this is the same answer that was given to you in your other thread (Z axis "jumps" up at a certain point) where you asked the same question.

Post by **WillAdams** » Tue Sep 13, 2016 1:50 pm

Also, FWIW, this is on the wiki as well: http://www.shapeoko.com/wiki/index.php/ ... Shapeoko_3

The Shapeoko Forum

Need new limit switch- Z axis lets go and destroyed it. Part

Need new limit switch- Z axis lets go and destroyed it. Part

Re: Need new limit switch- Z axis lets go and destroyed it.

Re: Need new limit switch- Z axis lets go and destroyed it.

Re: Need new limit switch- Z axis lets go and destroyed it.