v-wheels technical drawing

[grep]

hi there

I was wondering, as the shapeoko 3 is open hardware, if there is a technical drawing for the v-wheels used by the shapeoko 3. I looked everywhere, couldn't find it.

Thanks

[WillAdams]

It ought to be in: https://github.com/sparkfun/SparkFun_Stepoko

Apparently the design has been changed since https://www.shapeoko.com/wiki/index.php/Parts#All_Axes was written.

[grep]

@Willadams thanks! Can they share the new design?

[WillAdams]

Ask at support@carbide3d.com --- I'm not 100% sure about whether or no the design has changed (and unfortunately, gave away my Shapeoko 1 and Ordbot, so can't check) --- just some folks have said parts which ought to fit don't.

[grep]

I'm tempted to think the delrin wheel design is the same, but the difference is in the outer diameter of the precision washer