I have my machine (XXL) all set up and ready. I go to the homing setup, follow step by step, and after about the 3rd step, where it says "send config data" I immediately get an error message stating "program quit running". I am running Windows 10, plenty of memory, power to the controller is on, computer connected, but I am at a loss as to what may be happening. I am using the downloaded "Carbide Motion 4" as stated in instructions. There were several missing steps during assembly, so was something left out in the part also? Thanks for the help, and I do have an email message into Support, I will call tomorrow also. Just would like to get some idea as to what is going on....
Jeff

Also, in the LOG window it says (1) State:Set Machine State: not connected
It was suggest that I open the log window and then in MDI sending $$ to the machine.... if I am in Log and then go back to Carbide Motion and click on MDI, nothing happens