OpenBuilds control

Post Reply
Lodds
Posts: 2
Joined: Thu Nov 05, 2020 7:51 am

OpenBuilds control

Post by Lodds » Tue Nov 17, 2020 4:32 pm

Hi there,

Not sure if anyone can help me.

I have recently purchased and built a Shapeoko XL and would like to use the Openbuild control instead of the Carbide motion controller.

I use Vetric Vcarve as design software and need to understand what toolpath output to send, do I use "Shapeoko" or "Openbuild GRBL toolpaths.

One other question is will the Shapeoko XYZ probe work with the openbuild control?

TIA

Post Reply