So I jumped the shark and decided to design the perfect "industrial" Shapeoko control package with the electronics that I pretty much already have.
I am still firmly in the design phase. I have attached two 3D PDFs - one with the full chassis, and the second has the lid and side panels hidden so you can see the goodies inside.
There is a ton I still have to do - I have to:
- figure out the electrical connections for the teensy++2.0 using Generic HID to interface the switches, LEDs in the buttons, and the two relays for AUX A and AUX B.
- do the legends for the rear panel
- Add the fans to my power interconnects
- design all cables
- and buy a 19" rack.