Anyone know anything about the Spindle Control from Kosme?

Post Reply
CptanPanic
Posts: 98
Joined: Tue Apr 10, 2012 3:14 pm

Anyone know anything about the Spindle Control from Kosme?

Post by CptanPanic » Sun Jun 10, 2012 2:55 pm

I was browsing the wiki and came upon the circut for a Spindle Speed controller. It includes some schematics and such, but it says it has not been tested. Anyone know if there has been any more development on this?

http://www.shapeoko.com/wiki/index.php/Spindle_Control

CptanPanic
Posts: 98
Joined: Tue Apr 10, 2012 3:14 pm

Re: Anyone know anything about the Spindle Control from Kosm

Post by CptanPanic » Sun Jun 10, 2012 5:51 pm

FYI: I found this looking around the web. Seems it does the same thing. http://www.inmojo.com/store/inmojo-mark ... er-module/

Post Reply