Axis USB TB6560 Nema23 3.0A

[m_itko]

Hello,
Is possible use and config this driver board:
http://www.ebay.com/itm/261491784208?_t ... EBIDX%3AIT
for working whit ShapeOko and dual Nema 23 stepper motor on Y-Axis?

[lioramsalem]

it has 4 drivers so I don't see why no.
In Mach3 you can slave one motor to the other and I'm pretty sure it's the same on other software..

LA

[m_itko]

it has 4 drivers so I don't see why no.
In Mach3 you can slave one motor to the other and I'm pretty sure it's the same on other software..

LA

What electronics use for you machine?

[lioramsalem]

it has 4 drivers so I don't see why no.
In Mach3 you can slave one motor to the other and I'm pretty sure it's the same on other software..

LA

What electronics use for you machine?

Currently I use a cheap ~10$ BOB wired to the gshield, Mach3 with Gerry's 2010 screenset and VistaCNC MPG.

I really like this setup, especially the semi-automatic tool change and the fact that I only use the computer once, to load the g-code file.
here's a video to the z probing method:


LA

[m_itko]

This is my machine:

WP_000697.jpg (73.32 KiB) Viewed 1154 times

I work with laptop and want USB driver board working with dual motor for Y-Axis.My Nema 23 does not work well with gShield.

Recommended for me driver board or change Nema 23 with Nema 17!