cable lengths question

Posts: 174
Joined: Thu Apr 12, 2012 2:49 pm

Re: cable lengths question

Post by alpha » Thu Apr 19, 2012 9:07 pm

edwardrford wrote:The best way I have found to determine cable length is to run each cable individually to the point you want to terminate it. Then, add a couple inches and lop it off. Repeat for each motor. Doing it that way you'll be sure not to short yourself.
Good point! I will do this in 60 days + 3 Days 8 Hours 2 Minutes 56 Seconds - just kidding!
Remember, my plan was to build all the electronic without having the mechanics... thanks for all the measurements.
I will visit my local electronics store and see if I can get some Molex connectors locally and some other connectors to make everything plugeable.


Post Reply