Z Axis - HELP!

Post Reply
ASUAlumni02
Posts: 24
Joined: Sun Aug 03, 2014 9:57 pm

Z Axis - HELP!

Post by ASUAlumni02 » Tue Oct 24, 2017 6:48 am

Greetings all...so I moved and now reassembling my Shapeoko 2. I ran the wires directly from the Z axis motor to the gShield, it gets power, holds tight but when I test it it does nothing...you can hear it wanting too...poor little fella. I have adjusted the pot screw to no avail. I then went and put it on both the X and Y axis positions and it works great while attached to the screw and not attached. This one is stumping me...help please.
Shapeoko 2, stock but have: DW660, 1000x1800, GT2 belts and ACME Z to install

Post Reply