cut2d
Re: cut2d
I use it and vcarve pro. They have a ton of training videos on their website. http://support.vectric.com/training-material/cut2d
Brian
Shapeoko 2 #I have no idea
HF cutout tool, 72oz nema 17 steppers, TB6600 stepper drivers, Mach3 control
Shapeoko 2 #I have no idea
HF cutout tool, 72oz nema 17 steppers, TB6600 stepper drivers, Mach3 control
Re: cut2d
I use Cut2d, I had to install a Post Processor file for Cut2d so it would work with grblShield, got it over at this pagehoggy38 wrote:any one using cut2d if so what is there workflow from design to cut ...thank,s...john
https://www.inventables.com/technologies/cut2d-15
I often make something simple in Cut2d, use the Shapeoko/grblShield Post Processor, then send that file to G-Code Sender.