Page 1 of 1

cut2d

Posted: Sun Mar 16, 2014 7:41 am
by hoggy38
any one using cut2d if so what is there workflow from design to cut ...thank,s...john

Re: cut2d

Posted: Sun Mar 16, 2014 3:21 pm
by Brian
I use it and vcarve pro. They have a ton of training videos on their website. http://support.vectric.com/training-material/cut2d

Re: cut2d

Posted: Mon Mar 17, 2014 3:07 am
by will1384
hoggy38 wrote:any one using cut2d if so what is there workflow from design to cut ...thank,s...john
I use Cut2d, I had to install a Post Processor file for Cut2d so it would work with grblShield, got it over at this page

https://www.inventables.com/technologies/cut2d-15

I often make something simple in Cut2d, use the Shapeoko/grblShield Post Processor, then send that file to G-Code Sender.