Page 1 of 1

Fusion 360 grbl Post Processing Script

Posted: Wed Jun 18, 2014 3:58 pm
by TheMonkeyStink
Hello Folks,

For those of you using Fusion 360 I have a request, could you try out the enclosed files to see if they work as post scripts for grbl/gShield? I've tried the gShield.cps and it appeared to work, but my design was fairly simple. The only apparent problem I had was that UGS seemed to have problems shutting down after processing the output file, but that could be due to the size of the file. Any input would be appreciated.

Re: Fusion 360 grbl Post Processing Script

Posted: Thu Jun 19, 2014 4:56 am
by arjan
Im using Inventor HSM with the tiny G post and it is ok(same posts same milling kernel) . Ugs is not the most stable solution but it works.

Verstuurd vanaf mijn GT-N7100 met Tapatalk