Can I go from Inkscape to F-Engrave?

Woodworker
Posts: 639
Joined: Tue Mar 11, 2014 1:37 am
Location: 5 miles north of Benson, NC

Re: Can I go from Inkscape to F-Engrave?

Post by Woodworker » Sat Sep 06, 2014 9:39 pm

Yep, better better dxf export. http://tim.cexx.org/?p=590
BRuce - SO2 #4798 - IC's Z axis upgrade, customized Z rail and Z motor mount, spindle Dewalt 611

Carl Fisher
Posts: 127
Joined: Fri Mar 07, 2014 1:36 pm

Re: Can I go from Inkscape to F-Engrave?

Post by Carl Fisher » Sun Sep 07, 2014 2:54 pm

Well, better better dxf doesn't work for some reason. Errors out when I try to save.

However I grabbed better dxf and it eliminated all of the artifacts so I'm happy. :mrgreen:

Woodworker
Posts: 639
Joined: Tue Mar 11, 2014 1:37 am
Location: 5 miles north of Benson, NC

Re: Can I go from Inkscape to F-Engrave?

Post by Woodworker » Sun Sep 07, 2014 6:02 pm

Super, I will make sure I have all of then installed and pick the best based on the subject.
BRuce - SO2 #4798 - IC's Z axis upgrade, customized Z rail and Z motor mount, spindle Dewalt 611

tbfleming
Posts: 89
Joined: Sat May 31, 2014 12:04 pm

Re: Can I go from Inkscape to F-Engrave?

Post by tbfleming » Thu Sep 11, 2014 11:56 pm

I released V Bit support for jscut tonight. See http://www.shapeoko.com/forum/viewtopic ... =40#p31432

Post Reply