Post processor for Shapeoko 2?

Post Reply
Christine88
Posts: 168
Joined: Tue Oct 07, 2014 4:16 pm

Post processor for Shapeoko 2?

Post by Christine88 » Fri Oct 17, 2014 10:50 pm

is there a specific post processor for Shapeoko that I could acquire? If not what do you guys use for milling and engraving? I'm using Artcam which has a lot of posts but so far the ones I've tried don't work right.

WillAdams
Posts: 8489
Joined: Mon Apr 09, 2012 6:11 pm
Location: Pennsylvania --- south of the Turnpike, East of US-15
Contact:

Re: Post processor for Shapeoko 2?

Post by WillAdams » Fri Oct 17, 2014 11:19 pm

The last time this was discussed: http://www.shapeoko.com/forum/viewtopic ... 125#p30919

This is linked to from the wiki: http://www.shapeoko.com/forum/viewtopic.php?f=30&t=773

This thread; http://forum.artcam.com/viewtopic.php?f=1&t=24938 says:
Use Mach3 PP for Shapeoko2 and GRBL
Shapeoko 3XL #0006 w/Makita RT0701 Router w/0.125″ and ¼″ Elaire precision collets
Nomad 883 Pro #596 (bamboo)

Post Reply