Designing & milling PCBs with free software

Post Reply
aam
Posts: 38
Joined: Sat Aug 30, 2014 6:17 pm

Designing & milling PCBs with free software

Post by aam » Sun May 17, 2015 11:48 pm

I've made a step-by-step tutorial about my PCB designing and isolation milling workflow using only free software.
You can find it here: http://www.instructables.com/id/PCB-des ... sing-free/
Hope it helps! :D
-1-3.jpg
-1-3.jpg (61.89 KiB) Viewed 384 times

Auarhau
Posts: 243
Joined: Tue Feb 25, 2014 8:46 pm

Re: Designing & milling PCBs with free software

Post by Auarhau » Mon May 18, 2015 6:27 am

Cool! This looks like something I could do:) Thanks for the tutorial. Pcb's always mystified me, but this looks doable. NEver heard of Fritzing before, I'll check it out:)
ShapeOko 2. Nema 17 74 oz·in. GAUPS shield on Arduino Uno. DRV8825 Drivers x4 . Kress 1050 FME-1. Z Acme Screw. Threaded inserts table.

Post Reply