Fusion 360 Self Un-installed

Post Reply
chomdh
Posts: 179
Joined: Sun Jan 19, 2014 3:43 pm
Location: Bettendorf, IA

Fusion 360 Self Un-installed

Post by chomdh » Wed Dec 23, 2015 12:51 am

My shortcut for Fusion 360 disappeared recently and I can no longer run the program. It seems to have disappeared from my computer! I went to re-install it a couple of times and it doesn't seem to complete the installation.

Has this happened to anyone else? I thought this was free for "makers". Does anyone know how I can get Fusion 360 back up and running? This is very strange.
Shapeoko2 #3702:
DW611, arduino uno, gshield v5, NEMA23's on X & dual Y, NEMA17 on Z with ACME rod, 9mm belts, Mean Well NES-350-24V power supply, re-inforced gantry rails.
Soon to have inventables spindle mount and 1M X axis.

WillAdams
Posts: 8608
Joined: Mon Apr 09, 2012 6:11 pm
Location: Pennsylvania --- south of the Turnpike, East of US-15
Contact:

Re: Fusion 360 Self Un-installed

Post by WillAdams » Wed Dec 23, 2015 1:53 am

Doesn’t it require that you re-new your eligibility on an annual basis?
Shapeoko 3XL #0006 w/ Carbide Compact Router w/0.125″ and ¼″ Carbide 3D precision collets

chomdh
Posts: 179
Joined: Sun Jan 19, 2014 3:43 pm
Location: Bettendorf, IA

Re: Fusion 360 Self Un-installed

Post by chomdh » Wed Dec 23, 2015 12:50 pm

After properly un-installing from control panel -> add/remove programs, then re-installing, I now have F360 working again.
I must have registered at one time because I don't have any sort of free trial countdown showing at the top of the screen.
Shapeoko2 #3702:
DW611, arduino uno, gshield v5, NEMA23's on X & dual Y, NEMA17 on Z with ACME rod, 9mm belts, Mean Well NES-350-24V power supply, re-inforced gantry rails.
Soon to have inventables spindle mount and 1M X axis.

Brian Stone
Posts: 295
Joined: Tue Oct 21, 2014 1:52 am
Location: Seattle, WA

Re: Fusion 360 Self Un-installed

Post by Brian Stone » Wed Dec 23, 2015 6:43 pm

Very strange. I would have reported that to Fusion 360 support before reinstalling. They're usually very responsive, and often have workarounds.
Shapeoko 2 #7353
1500x1000mm Shapeoko/X-Carve Hybrid, Nema-23's, Belt-Driven Z-Axis /w ACME Screw, Dewalt 611, Soundproof Enclosure
[Fusion 360 | Illustrator] -> Universal G-Code Sender

AnonymousPerson
Posts: 758
Joined: Sun Apr 26, 2015 1:16 pm
Location: 3753 Cruithne

Re: Fusion 360 Self Un-installed

Post by AnonymousPerson » Mon Jan 04, 2016 6:02 pm

Fusion 360 tries to upgrade itself every now and then (if there's an upgrade available when you start it).

Maybe something went wrong during one of those upgrades and left a semi-installed mess behind? :roll:
Shapeoko 3 #516

Post Reply