Carbie Motion issue?

Post Reply
penguin0456
Posts: 1
Joined: Fri Aug 14, 2015 12:55 am

Carbie Motion issue?

Post by penguin0456 » Sat Feb 17, 2018 7:13 pm

so I was a early adopter of the Shapeoko 3 and recently added limit switches. So as such I updated to the new software, however after setting everything up I noticed that if I rapid position in carbide motion it acts as if my machine is a XXL but its really just a standard sized Shapeoko, and in setting it shows the machine in the correct size. So i am confused if this is a machine issue or the software or what really.

I also am not sure if this should be in the subject but perhaps? because its carbide motion?

Post Reply