Stray points appear after GRBL post

Post Reply
PaulDeyo
Posts: 1
Joined: Sun Dec 03, 2017 4:12 pm

Stray points appear after GRBL post

Post by PaulDeyo » Mon Feb 18, 2019 2:01 pm

I use Fusion 360 to create geometry and develop cutterpath for my Shapeoko 3. After creating a "Trace" cutterpath and posting through a generic GRBL post processor I find I have some points fall below the table that were not displayed (or wanted) between simulating the path in Fusion and loading the path into UGS. I've attached an image comparing the Fusion path and the path that displays in UGS. I have run the check in UGS and the points are not just a graphic glitch.

How were these points generated? How can I avoid creating them?

Thanks for your help.

FusionUGSDisplay.png
FusionUGSDisplay.png (155.67 KiB) Viewed 163 times
CrownHexGrid1.32Flat.nc
(15.01 KiB) Downloaded 10 times

Post Reply