Page 1 of 1

Clamps from CC

Posted: Thu Dec 05, 2019 10:57 pm
by dcoalc70
I downloaded , and successfully ran the 4 clamp program. However I used a 201 square bit which has a 1/4 shank. It of course overcut the dimensions, thus leaving a complete cutout of the shape of the clamp having carved out the entire middle area of the shape (I am guessing the 201 bit is too wide).
I think the tool change message said use a 102? cutter which I don't have. So looking at the 101 and 102 cutters, they are 1/8 inch shanks. I purchased the Dewalt router with my Shapeoko XL but it does not have adapters for 1/8 shafts.
So do I buy the Amana RB 102 1/4 to 1/8 adapter, or does Carbide Create sell 1/4 shaft bits that match the 101 or 102 bits?
I would hate to purchase knockoffs.
Also, it would be kind to add suggested bit numbers on the downloads.


Re: Clamps from CC

Posted: Sat Dec 07, 2019 9:30 am
by WillAdams
A collet reducer will work --- we stock one at: ... ing-collet

or you can buy a 1/8" collet for the DeWalt from: ... #dwpanchor

Re: Clamps from CC

Posted: Mon Dec 09, 2019 1:07 am
by dcoalc70

Thank you.