epoxy resin table

Talk about all things CNC
Post Reply
Posts: 1
Joined: Thu Aug 13, 2020 8:49 am
Location: Clifton

epoxy resin table

Post by Alidig » Sat Aug 15, 2020 5:56 pm

I am going to begin working on my first epoxy river table this weekend. I have been doing some research and watching some videos.

Does anyone have any experience making these that can give any tips?

Can it be sent through the planer after the epoxy has cured? I have a helical head.
My epoxy says cures at 75-80 degrees in 72 hours. I am unable to keep my house or shop that warm during the winter. I did a few little test pieces at around 68-70 degrees and seemed to cure fine. Do you see an issue with making the table over the winter at those temps?

Any tips/help is really appreciated!

Post Reply