Page 3 of 3

Re: Live in the Columbus Ohio area

Posted: Tue Jul 02, 2019 11:01 am
by Jeff
Can you tell me how the spindle rpm is controlled .
Jeff

Re: Live in the Columbus Ohio area

Posted: Wed Jul 03, 2019 12:37 am
by tim614
As you can see in the kit
It comes with a VFD controller and you have to program it to work with the spindle.
I’ve have read several posts regarding programming the VFD where people have said it was too complicated so I was worried but once I had a chance with it I found it really wasn’t that hard to get it programmed

Re: Live in the Columbus Ohio area

Posted: Thu Aug 01, 2019 11:57 pm
by neilferreri
Hey guys,
I'm in Dublin also. I've had a SO3 for a few years and upgraded to the XL a couple years ago.
I'm pretty active in the C3D forum, but, to be honest, I have barely looked at this one.
Neil