Page 1 of 1

Rapid Rate

Posted: Sun Mar 10, 2019 11:58 am
by Jeff
In Vcarve pro there is a time estimator . it needs to know that the Rapid Rate of the machine is.
Where can I find out what that would be for the Shapeoko XXL.
Thanks Jeff

Re: Rapid Rate

Posted: Sun Mar 10, 2019 1:32 pm
by WillAdams
This is a setting in Grbl.

The defaults for the Shapeoko 3 running Grbl 0.9 are at: https://docs.carbide3d.com/software-faq ... -settings/

You can check your specific machine / version by connecting to it, opening the Log, then sending $$ and checking the log.

Re: Rapid Rate

Posted: Mon Mar 11, 2019 11:59 am
by Jeff
That link is probably good for some one that knows what all that means. If that is what it takes to find the rapid motion of the machine then I am out of luck.
I was hoping that is was just a # that someone knows.
Jeff

Re: Rapid Rate

Posted: Mon Mar 11, 2019 6:44 pm
by twforeman
$110=5000.000 (x max rate, mm/min)

5000 mm/min

Not that difficult...

Re: Rapid Rate

Posted: Mon Mar 11, 2019 10:00 pm
by Jeff
Thanks For the reply and Speed rate.
Jeff

Re: Rapid Rate

Posted: Tue Mar 12, 2019 3:47 pm
by twforeman
That's the "default" value. It may be different on the machine.

The best way to know for sure is to open the terminal and send $$ to get the settings and see what $110 is set to.