Page 1 of 1

Cleaning bits

Posted: Wed May 22, 2019 7:17 am
by apspurgeon
HI all,

I had a number of bits with blacken burn marks and hardened/baked on debris.
They may be a bit blunted, but still have life but were marking the material I am milling with burn marks from the baked on debris.

I decided to try putting some detergent / degreaser in an ultrasonic cleaner (like for jewelry)

The outcome was impressive! I could see the marks/degree floating away from the endmill and after 10mins they came out like (almost) new.
Sadly I didn't take before photo's.....

Re: Cleaning bits

Posted: Sun Jul 21, 2019 11:56 am
by Jeff
The other product you can use and I use it on saw blades as well is PB Blaster.
Jeff