Page 1 of 1

3D Printing software

Posted: Sat Jun 21, 2014 12:20 pm
by WillAdams
Working on this now.

Since it's not a focus of the project, I've isolated it on the 3D printing upgrade page: http://www.shapeoko.com/wiki/index.php/ ... g#Software

Eventually I'll probably remove the 3D printing oriented things from the normal software pages --- or should the integration go the other direction? Not wild about that since the software pages are already really cluttered (if anyone is inclined to test software or recommend that it get promoted from the ``to be investigated'' link buckets at the bottom of the pages I'd be grateful).