3d printer upgrade

deejayspinz
Posts: 96
Joined: Wed Oct 17, 2012 9:33 am
Location: Burlington Ontario, Canada

Re: 3d printer upgrade

Post by deejayspinz » Wed Oct 24, 2012 4:55 pm

I'm following the GnexLab approach.. The've blogged about it here - check out the Mach3 addon link in the left side menu. Because I dont have my ShapeOko yet, I have not been able to do a full circle test, but I already have the addon w/ Slic3r loaded into Mach. My version seems to have some issues, but I think the concept is that you open Mach, run the addon that will take a 3D file, slice it up, produce g-code and allow you to post to Mach to be printed. Looking very promising.

jrsteensen
Posts: 118
Joined: Mon Jun 11, 2012 9:29 pm

Re: 3d printer upgrade

Post by jrsteensen » Wed Oct 24, 2012 6:43 pm

DJ,

I added your ideas to the wiki - http://www.shapeoko.com/wiki/index.php/ ... ting_Mach3

Edward, any chance of getting it added to the upgrades in the sidebar, or is that strictly for proven upgrades?

Improbable Construct
Posts: 997
Joined: Tue Apr 10, 2012 3:21 am
Location: Fairhope, AL
Contact:

Re: 3d printer upgrade

Post by Improbable Construct » Wed Oct 24, 2012 8:58 pm

Added to the Wiki side bar.

Upgrades:

Mach3 3D Printing

Nice work on the Wiki page.
Shapeoko #Classified some of the bolts may be original parts.
Shapeoko 1 # ???? Stainless plates, still in the box.
Shapeoko 2 # 3926 not stock
Shapeoko 3 # 0003
Store:
http://ImprobableConstruct.com
Twitter:
https://twitter.com/ImprblConstruct

LTMNO
Posts: 172
Joined: Sat Mar 09, 2013 2:56 am

Re: 3d printer upgrade

Post by LTMNO » Sat Mar 16, 2013 1:36 am

Very Cool... great wiki update with BOM, much appreciated... sounds like the next project after the first one takes off...
or is it the laser before this one? baby steps...
ShapeOko #1508, TinyG Controller, Dual Y, ACME Z-Axis, MeanWell(S-350-24v), NEMA 23's, 1m Squared t-slot table, OpenRail and the Original Z Makerslide and all Motor Plates...

Post Reply