Page 1 of 1

Way to check sliced G-code for voids?

Posted: Sun Aug 03, 2014 5:20 pm
by WillAdams
Is there a tool for doing an analysis of generated G-code to determine if the infill is solid / optimal?

I'm printing a repair part for my lawnmower, and wanting it to be as solid as possible, set it to solid infill --- but even though I'm fairly certain that I've got my extruder rate set to be too high (still calibrating, but it's leaving bulges on the top of layers at points of transition), there're gaps around voids in the model.