Official SO3 Hello World

Post by **WillAdams** » Thu Jun 18, 2015 5:17 am

This is on the Carbide3D knowledge base site:

http://docs.carbide3d.com/article/37-sh ... ello-world

Looking forward to seeing them posted here and to the wiki.

Brian Stone · Post by **Brian Stone** » Thu Jun 18, 2015 6:55 am

Minor spelling error...

6.) Job pen down until it's *almost* touching the paper.

Hans · Post by **Hans** » Thu Jun 18, 2015 12:41 pm

Racing league, racing league, racing league!

I like the variety of different text sizes, that should make it easier to see any problems. Order of operations is probably efficient, but I'd prefer it didn't do SHAPEOKO in parts as if the machine was easily distracted.

Post by **twforeman** » Thu Jun 18, 2015 2:15 pm

Excellent. I'll have to see how fast I can run this.

Defy · Post by **Defy** » Fri Jun 19, 2015 12:40 am

Just makes me want a carbide 3d sticker for my shapeoko...

Post by **edwardrford** » Fri Jun 19, 2015 2:18 am

Defy wrote:Just makes me want a carbide 3d sticker for my shapeoko...

Me too!

We had a stack of those badges that we use for all of our Nomad machines. Ends up, they look great on the S3 spindle mount too!

We've ordered a bunch more, once they're delivered, we'll make them available.

-Edward

Post by **twforeman** » Fri Jun 19, 2015 2:35 am

Well that was fun. I cranked up the settings on my machine and ran this Hello World at 35,000 mm/min. I set the acceleration rate to 500 also. The machine did it but it wasn't super happy about it.

I shot some video, but it's out of focus, so I'll have to do it again.

woodworkerbob · Post by **woodworkerbob** » Fri Jun 19, 2015 3:21 am

WillAdams wrote:This is on the Carbide3D knowledge base site:

http://docs.carbide3d.com/article/37-sh ... ello-world

Looking forward to seeing them posted here and to the wiki.

For those of us Luddites that run jobs in inches, DON'T RUN THIS GCODE after any of those jobs. I think without the G21 command the controller stays in "inches" mode. Maybe a smarter person knows that the controller reverts to millimeters, but I haven't tested this.

Bob

CastIrony · Post by **CastIrony** » Fri Jun 19, 2015 5:58 am

twforeman wrote:Well that was fun. I cranked up the settings on my machine and ran this Hello World at 35,000 mm/min. I set the acceleration rate to 500 also. The machine did it but it wasn't super happy about it.

I shot some video, but it's out of focus, so I'll have to do it again.

Yeah, but where will you get more paper?

Jem-tech · Post by **Jem-tech** » Mon Jun 29, 2015 10:31 am

Just got my new board in and did a few hello worlds.

The Shapeoko Forum

Official SO3 Hello World

Official SO3 Hello World

Re: Official SO3 Hello World

Re: Official SO3 Hello World

Re: Official SO3 Hello World

Re: Official SO3 Hello World

Re: Official SO3 Hello World

Re: Official SO3 Hello World

Re: Official SO3 Hello World

Re: Official SO3 Hello World

Re: Official SO3 Hello World