Milling bevels and through-holes in a large heatsink

Share your Shapeoko created projects!
Post Reply
Brian Stone
Posts: 295
Joined: Tue Oct 21, 2014 1:52 am
Location: Seattle, WA

Milling bevels and through-holes in a large heatsink

Post by Brian Stone » Tue Aug 16, 2016 10:23 pm

Thought I'd post this, since it's sort of the first big chunk of aluminum I've milled on my S2. I've done some smaller aluminum projects in 6061 bar stock, but those were just simple experiments that didn't really teach me how to mill aluminum.

A friend of mine had a large heatsink (about 8" square) that required modification and mounting holes drilled. I offered to do the job on my S2 for the extremely generous price of one beer. Here's the result.

RPM: 20,000
MILL: 1/4" 2-Flute Square

45 degree bevels --
Feed: 1200mm/min
DOC: 0.25mm

Ratchet clearance helical bores --
Feed: 800mm/min
DOC: 0.25mm per helix revolution

Through hole helical bores --
Feed: 300mm/min
DOC: 0.1mm per helix revolution

The through holes were milled in 2mm depth increments though 7.5mm total thickness. After each increment the end mill was raised to clear chips.
20160814_201008.jpg
20160814_201008.jpg (115.85 KiB) Viewed 830 times
20160814_200923.jpg
20160814_200923.jpg (140.36 KiB) Viewed 830 times
20160814_200849.jpg
20160814_200849.jpg (133.02 KiB) Viewed 830 times
Incidentally, the beer was excellent and more than adequate compensation.
Shapeoko 2 #7353
1500x1000mm Shapeoko/X-Carve Hybrid, Nema-23's, Belt-Driven Z-Axis /w ACME Screw, Dewalt 611, Soundproof Enclosure
[Fusion 360 | Illustrator] -> Universal G-Code Sender

zerblatt007
Posts: 196
Joined: Tue Sep 11, 2012 7:48 am
Location: Bergen, Norway
Contact:

Re: Milling bevels and through-holes in a large heatsink

Post by zerblatt007 » Wed Aug 17, 2016 8:00 am

Nice!
Was it difficult to hold it down securly?
Shapeoko #958: Dual-Y drive, Double-X, Belt on outside, 1m Y-Axis, Acme Z, Opened up and boxed in. Kress 1050 Spindle.

Brian Stone
Posts: 295
Joined: Tue Oct 21, 2014 1:52 am
Location: Seattle, WA

Re: Milling bevels and through-holes in a large heatsink

Post by Brian Stone » Wed Aug 17, 2016 4:30 pm

Not difficult at all. I used just a few strips of double-sided foam tape.
Shapeoko 2 #7353
1500x1000mm Shapeoko/X-Carve Hybrid, Nema-23's, Belt-Driven Z-Axis /w ACME Screw, Dewalt 611, Soundproof Enclosure
[Fusion 360 | Illustrator] -> Universal G-Code Sender

Post Reply