Hi, I used two extrusion at the bottom these are where the end-plates also attach to https://www.inventables.com/technologie ... -extrusion 500mm. Then I used the insertion nuts https://www.inventables.com/technologies/insertion-nuts the bolts are in the bottom slots of course you need these types (https://www.inventables.com/technologie ... -cap-screw) so they will fit in I used the 12mm length. There are also 5mm holes from the top (20mm from the end) to be able to tight the screws...PsyKo wrote:Nice work you have done so far.
How did you assemble your T-Slot table ?
I'm planning to buy these one http://fr.misumi-ec.com/eu/ItemDetail/10302261820.html (HSFQN4-15250), ut I'm not sure how to assemble them together, and with the base extrusion (rail where the plates are).
And BTW, what is the long threaded rod made for ? (between the 2 Y axis motor )
Keep up the good mod
in pratice it looks like this: