New HDZ-Problem w/ Initial Homing (Z Axis)

Post Reply
DW Woodworking
Posts: 9
Joined: Wed Jan 23, 2019 11:16 pm

New HDZ-Problem w/ Initial Homing (Z Axis)

Post by DW Woodworking » Thu Jan 16, 2020 2:41 am

Hey Guys!

Just finished installing the HDZ on a 1 year old machine and now cant get the initial homing completed. It appears the "Z" axis is homing down away from the limit switch and not upward towards its mounted position. I have tried to reverse the wires, as stated in previous threads, however it didn't work. I recall loosely a section where you can change the GRBL settings to reverse a motor, but don't know if that's the step I need to take to complete. Open for suggestions.


V/r,

John

Post Reply