Discussion about the arduino based g-code interpreter, grbl
1 post • Page 1 of 1
Hooked up a Zprobe to my Shapeoko 3 and I use UGS as my code sender. I typed in a macro code that was given to me by a dependable source ( Phil Johnson ). When the macro code is activated the router bit is supposed to touch plate 2x and then go back up and it's ready. Well mine does that but when it goes back up I get an error message thus not allowing me to use the Zprobe. I have added a picture that shows the macro code and the error message. Does anyone know why I'm getting this message, how to fix it and or is there another code I need to use. Once again I use UGS and have no intentions of changing my sender.