Upload a .hex? Xloader fail

Discussion about the arduino based g-code interpreter, grbl
Post Reply
loopingz
Posts: 107
Joined: Fri Jul 27, 2012 5:00 pm

Upload a .hex? Xloader fail

Post by loopingz » Sun Dec 01, 2013 4:28 pm

I could not upload grbl 0.8c with Xloader. It got stuck both try.
I defrozed my arduino using http://www.ngcoders.com/downloads/ardui ... rogrammer/ definetely working better. Might be listed at least as alternative on the wiki...
My grbl is working again. Anyway when I do $ it says 0.8a, is it normal? It was 0.8c hex.
Shapeoko 1. Dual Y 1m with Name 17 (twice lower torque as the original motor). Double Xrails side to side. Acme-Z. Metalspacers.Wood 22mm waste board. Kress1050 with custom holder. Arduino GRBL + GRBL shield.

cvoinescu
Posts: 4442
Joined: Thu Jul 19, 2012 6:50 pm
Location: Camberley, UK
Contact:

Re: Upload a .hex? Xloader fail

Post by cvoinescu » Mon Dec 02, 2013 11:56 am

loopingz wrote:Anyway when I do $ it says 0.8a, is it normal? It was 0.8c hex.
Of course not. It should say 0.8c.
Proud owner of ShapeOko #709, eShapeOko #0, and of store.amberspyglass.co.uk

Post Reply