I'm sure this information was once posted here in the forum, but I can't find it.

Regards
Harald
Hi Harald,HarryT wrote:I want to use a Kress Spindle Motor cause this is easier to get here in Germany. Therfore I need another spindle mount. To prepare this while waiting for my SO3 I should know the distances of the holes for the spindle mount on the Z Axis Carriage Plate in vertical and horicontal direction. These are 5mm holes, aren't they?
I'm sure this information was once posted here in the forum, but I can't find it.![]()
Regards
Harald