CNC shield V4 Arduino Nano not working

Discussion about the arduino based g-code interpreter, grbl
Post Reply
alhaddar
Posts: 22
Joined: Mon Nov 18, 2013 8:17 pm

CNC shield V4 Arduino Nano not working

Post by alhaddar » Sun Jun 12, 2016 10:50 pm

On my CNC shield V4, the STEP and DIR was not corresponding between the pin layout from the Android Nano and the step driver board. After switching both pin the bor start to work

Now how are changed Pins by programming
I ask you my friends on the way, because I do not have any idea how to change


https://www.youtube.com/watch?v=ZX3t-2s3XUo

Post Reply