Scaled-Up 54" x 54" Shapeoko

discussion of design changes / improvements / suggestions

Re: Scaled-Up 54" x 54" Shapeoko

Postby superklaub » Sun Feb 11, 2018 1:47 am

Hi Ben,

During the build I laid a very fine metal file flat on each of the butt joints and worked it back and forth until the surfaces were smooth. I made sure I couldn't hear or feel any bumps or ticks as the v-wheels rolled over the butt joints. I really can't even tell there's a joint there. The workpieces turn out great.

Best Regards, Kevin
superklaub
 
Posts: 9
Joined: Sat Apr 29, 2017 2:49 am

Re: Scaled-Up 54" x 54" Shapeoko

Postby WesjTX » Sun Apr 15, 2018 8:15 pm

Kevin,

What is the table size you built for the table your XXXL unit is sitting on? I just ordered a Shapeoko3 and the XXL expansion pack as I also need the ability to work on pieces up to 48” across. This build is my inspiration for my build. Thanks for any info you can help with.

Wes
WesjTX
 
Posts: 3
Joined: Sun Apr 15, 2018 6:22 pm

Re: Scaled-Up 54" x 54" Shapeoko

Postby superklaub » Sun Aug 05, 2018 3:27 am

Wes, I apologize for the extremely late response. The vacuum table measures 54" square. The steel tubes under the bed make a 72" square support grid.

Best Regards, Kevin
superklaub
 
Posts: 9
Joined: Sat Apr 29, 2017 2:49 am

Re: Scaled-Up 54" x 54" Shapeoko

Postby MikeA » Mon Aug 27, 2018 1:34 am

infinity06 wrote:Hows is it cutting with the expansion? I am on the fence ready to buy a shapeoko but only if i can expand it.

Me too. I want to build custom furniture for a Victorian house and need the 48" cut capability. I'm like you, on the fence.
MikeA
 
Posts: 8
Joined: Mon Jul 09, 2018 9:54 pm

Re: Scaled-Up 54" x 54" Shapeoko

Postby MikeA » Mon Aug 27, 2018 1:39 am

I'm new to 3D routing and haven't bought the Shapeoko yet, The issue I have is the cutting width as I build Gothic and Victorian furniture. The 54" cutting width would be ideal. Are you or will you create an upgrade kit for the rest of us. I'm not going to have a problem with buying it from you. I was planning to get the Shapeoko 3 XXL anyways. Please tell me you can help us out by doing a how to, or creating a kit etc. How well does the upgraded 54" cut. Have you had any problems? Thanks
MikeA
 
Posts: 8
Joined: Mon Jul 09, 2018 9:54 pm

Previous

Return to Design Ideas

Who is online

Users browsing this forum: No registered users and 1 guest