Small trophy shelf - ideas needed

discussion of design changes / improvements / suggestions

Small trophy shelf - ideas needed

Postby rvs0002 » Wed Sep 05, 2018 3:55 pm

I have been asked by a friend if I can make a shelf for a trophy his company was presented with. The trophy is 10x10 at the base and about 14 inches tall. He also says it weighs about 5 to 7 pounds, so it is pretty stout. I could do a simple square with a bracket under it, but was kind of wanting to make it a little nicer.

If anybody has seen any designs they think might work I would love to see them. I don't have much of a "make-it-from-scratch" imagination...I kind of need to see something first and then start from there.

Thanks in advance,
John
rvs0002
 
Posts: 2
Joined: Wed Mar 28, 2018 3:47 pm

Re: Small trophy shelf - ideas needed

Postby madhatter » Wed Sep 05, 2018 9:37 pm

If I am stuck, I just start googling for images of what I think I am looking for.

Maybe try doing an image search for corner flourishes and see if anything gets the ideas flowing.

It's not a bracket, but a start.
SO3 #0054
DWP611 - SuperPID
Prusa i3 MkII
SolidWorks 2015
madhatter
 
Posts: 160
Joined: Sat Mar 21, 2015 1:33 am
Location: WA, USA

Re: Small trophy shelf - ideas needed

Postby rvs0002 » Mon Sep 17, 2018 2:29 pm

I have done a ton of googling, unfortunately can't find anything for just a single display piece shelf, but I will keep looking. Thanks for the reply!
rvs0002
 
Posts: 2
Joined: Wed Mar 28, 2018 3:47 pm


Return to Design Ideas

Who is online

Users browsing this forum: No registered users and 2 guests