dfx2gcode question

dfx2gcode question

Postby Baxter » Wed Jan 09, 2019 3:30 pm

It's a fairly simple one.

How does dfx2gcode know how many steps to send to make a cutter move 1 inch/cm? There must be somewhere where the actual distance the cutter moves for one pulse is fed into the system, but I can't see where that is...?

Or perhaps it's in another bit of software altogether?
Baxter
 
Posts: 24
Joined: Sun Dec 30, 2018 7:11 am

Re: dfx2gcode question

Postby Baxter » Wed Jan 09, 2019 7:10 pm

Ah - panic over - step resolution is done by GRBL.

I thought that was firmware that was burnt into a chip and couldn't be changed - but now I've found that you CAN change tables that it uses....
Baxter
 
Posts: 24
Joined: Sun Dec 30, 2018 7:11 am


Return to Software - CAD, CAM, Workflow Help

Who is online

Users browsing this forum: No registered users and 3 guests