XXL Drag Chain and the X axis homing switch

XXL Drag Chain and the X axis homing switch

Postby woodworkerbob » Thu Jan 24, 2019 5:56 pm

In the middle of installing an XXL and have not "taped" down the drag chain. However when the X-Z plate is all the way to the right, the drag chain seems to be catching on the bolt that holds the X homing/limit switch in place.

Is this normal? Did I do something wrong?

Bob
Shapeoko 3 - #13, dust deputy, precision collets, limit switches.
SVEMakerSpaces
woodworkerbob
 
Posts: 243
Joined: Tue Apr 15, 2014 6:31 pm
Location: SVEMakerSpaces - Mesa, AZ

Re: XXL Drag Chain and the X axis homing switch

Postby WillAdams » Thu Jan 24, 2019 7:23 pm

https://wiki.shapeoko.com/index.php/FAQ ... itch_screw

>Usually this can be adjusted by loosening the hardware in question, pulling it into the desired alignment, then tightening it, sometimes slightly bending the drag chain bracket up will help. One option is to only use one screw in the rearmost hole on the bracket and the frontmost on the drag chain. Some folks have found it helpful to put a couple of washers under the drag chain bracket to push it out into a better alignment (the drag chain should slightly hang off the rear of the extrusion), other solutions include sourcing a longer drag chain bracket from the hardware store, or placing a piece of angle on the extrusion to guide the drag chain.

>A straight-forward solution is to only use one hole (rearmost on bracket, nearest on drag chain).
Shapeoko 3XL #0006 w/Makita RT0701 Router w/0.125″ and ¼″ Elaire precision collets
Nomad 883 Pro #596 (bamboo)
WillAdams
 
Posts: 8462
Joined: Mon Apr 09, 2012 6:11 pm
Location: Pennsylvania --- south of the Turnpike, East of US-15


Return to Assembly

Who is online

Users browsing this forum: No registered users and 2 guests