Build Errors

Build Errors

Postby apopj » Fri Mar 08, 2019 3:07 pm

Just a couple of quick notes....

Just received my Shapeoko 3 XXL, in the process of assembly. Just a couple of errors in the instructions.....

1. Installing the Y-Axis Drag Chain Bracket#: My unit only had the two lower spacers installed. It says to loosen the TWO screws, but there was only one. I found a spacer in one of the bags and used it to mount the bracket. If that spacer is needed further into the build, assembly will be delayed while waiting for replacement...


2. During inventory, the zip ties and cleaning pads were not in the box listed. they were in a different box. Not a biggie but just wanted to list it.



Also, while you can figure out the drag chain routing, it is a bit confusing. Perhaps a picture of the entire chain system in that section of assembly would help.


So, back to assembly... wish me luck.


Jeff
apopj
 
Posts: 11
Joined: Sun Dec 30, 2018 3:55 am
Location: Portage Lakes, Ohio (just South of Akron)

Re: Build Errors

Postby WillAdams » Sat Mar 09, 2019 5:57 am

Please contact us at support@carbide3d.com if you need anything.
Shapeoko 3XL #0006 w/Makita RT0701 Router w/0.125″ and ¼″ Elaire precision collets
Nomad 883 Pro #596 (bamboo)
WillAdams
 
Posts: 8462
Joined: Mon Apr 09, 2012 6:11 pm
Location: Pennsylvania --- south of the Turnpike, East of US-15


Return to Assembly

Who is online

Users browsing this forum: No registered users and 1 guest

cron