Cutting parts on 96" long Wood

Talk about all things CNC
Post Reply
Jeff
Posts: 109
Joined: Thu Jun 29, 2017 12:33 pm

Cutting parts on 96" long Wood

Post by Jeff » Thu Jun 13, 2019 12:02 pm

Hi have a question
Because on the XXl you can cut 32" wide. By adding a piece of mdf to your spoil board you can lay a long piece of wood say 72" long by 30" wide on top.
I could cut base cabinet sides 2 at a time. Or top cabinets say 42 tall.
Cutting dados for the bottom rabbit for the back and holes for shelves and make left and right sides.
I would put guilds on both sides to keep the material straight to the bed and hold it down.Yes I would have to support the material off the back of the bed.Cut the first side then slide the material forward to cut the second part.
Using the top left bottom corner to set my x-y-z off.
What I am trying to figure out how to do is to set the start point for the second side.
Thanks Jeff

Post Reply