Diamond Drag Bit - adaptor recommendations

General Discussion about anything!
Post Reply
TexasCarver
Posts: 1
Joined: Mon Sep 09, 2019 7:30 pm

Diamond Drag Bit - adaptor recommendations

Post by TexasCarver » Wed Sep 11, 2019 3:56 pm

Hello folks I am wondering if any of the Forum members are using a Diamond Drag bit with 1/2" collet on the Dewalt DWP611 (which expects 1/4" bits) and if so which adaptor your are using/would recommend?

We are just getting started using Shapeoko XXL for engraving so keen to learn from those who have done this?

Thanks!

/Tex

Post Reply